50 lines
2.4 KiB
Text
50 lines
2.4 KiB
Text
Known bugs and restrictions of Emu48 V1.66
|
||
------------------------------------------
|
||
|
||
- the following I/O bits aren't emulated (incomplete)
|
||
DTEST (0x102) [VDIG LID TRIM]
|
||
DSPCTL (0x103) [LRT LRTD LRTC BIN]
|
||
LPD (0x108) [LB2 LB1]
|
||
LPE (0x109) [GRST RST]
|
||
CMODE (0x10A) Mode register
|
||
IOC (0x110) [ERBZ]
|
||
RCS (0x111) [RX RER RBZ]
|
||
SRQ1 (0x118) [ISQR]
|
||
SRQ2 (0x119) [LSRQ]
|
||
IRC (0x11A) [IRI EIRU EIRI IRE]
|
||
LCR (0x11C) [LBZ LBF]
|
||
- the baudrates 1920, 3840, 7680 and 15360 aren't emulated on most
|
||
operating systems
|
||
Windows 95a 1920, 3840, 7680 work, 15360 fail
|
||
Windows 98, NT4.0, 2000, XP all baudrates fail
|
||
- problems when receiving a break signal on the serial port
|
||
Windows 98, NT4.0 SP4 no retrigger on port open
|
||
Windows 98 timing problems setting the RER bit
|
||
Windows 2000 SP2 no known problems
|
||
- System-RPL commands VERYVERYSLOW, VERYSLOW and SLOW depends on PC
|
||
speed (are realized as simple down counter in ROM)
|
||
- display updating differs from the real machine
|
||
- screen VBL counter values may skip after large display operations
|
||
like turning on or updating the whole display
|
||
- read on an unconfigured address (open data bus) will not show the
|
||
same value like a real calculator
|
||
- the Yorke hardware signals BEN and DA19 aren't fully supported,
|
||
because the emulator don't use a multiplexed AR18 / NCE3 data line
|
||
-> all programs that run on a real calculator will run as well,
|
||
programs with incorrect DA19 / BEN handling may run on the
|
||
emulator but will crash on a real calculator
|
||
- incomplete reset logic of the bank switcher FF, on real
|
||
calculators a reset happen after about 4s in deep sleep, in the
|
||
emulator this happens immediately
|
||
- no MP interrupt on card control circuit or timer restart
|
||
- Shell OS: clock isn't synchronized with real time
|
||
- HP49G: the flash memory is emulated now with some restrictions
|
||
- no flash programming times, the flash state machine returns
|
||
immediately the ready signal
|
||
- only one write buffer, second not needed because of prior reason
|
||
- not fully tested, especially the status byte may return
|
||
incorrect values (error bits)
|
||
- quitting the emulator while programming the flash isn't allowed,
|
||
because the content of flash state machine isn't saved so far
|
||
|
||
06/20/23 (c) by Christoph Gie<69>elink, c dot giesselink at gmx dot de
|