slackbuilds_ponce/network/ipv6calc
Chris Abela 267caa0dc0 network/ipv6calc: Added (utility to convert IPv6 addresses)
Signed-off-by: dsomero <xgizzmo@slackbuilds.org>
2011-07-14 21:54:02 -03:00
..
ipv6calc.info network/ipv6calc: Added (utility to convert IPv6 addresses) 2011-07-14 21:54:02 -03:00
ipv6calc.SlackBuild network/ipv6calc: Added (utility to convert IPv6 addresses) 2011-07-14 21:54:02 -03:00
README network/ipv6calc: Added (utility to convert IPv6 addresses) 2011-07-14 21:54:02 -03:00
slack-desc network/ipv6calc: Added (utility to convert IPv6 addresses) 2011-07-14 21:54:02 -03:00

ipv6calc is a small utility written in programming language C to
manipulate (not only) IPv6 addresses. Intentions were converting a
given IPv6 address into compressed format, converting a given IPv6
address into the same format like shown in /proc/net/if_inet6 and
(because it was not difficulty) migrating the Perl program ip6_int
into. Now only one utility is needed to do a lot.

This utility was also used in the past to extend features on
network-functions-ipv6 library, used by initscripts-ipv6.

To enable IP2Location support you will need to install C-Ip2location
first, and then pass:

  IP2LOCATION=yes

to this Slackbuild.