slackbuilds_ponce/network/NetworkManager
Robby Workman c6c85f937c network/NetworkManager: Minor default config changes
This commit sets dhcpcd as the dhcp client for NM to use and adds
some comments to /etc/NetworkManager/nm-system-settings.conf so
that it's clearer where to look for more information...
Thanks to Dan Williams (NM Upstream Dev) for help with this.

Signed-off-by: Robby Workman <rworkman@slackbuilds.org>
2010-08-23 00:53:22 -05:00
..
doinst.sh
fi.epitest.hostap.WPASupplicant.service
NetworkManager.info
NetworkManager.SlackBuild network/NetworkManager: Minor default config changes 2010-08-23 00:53:22 -05:00
nm-system-settings.conf.new network/NetworkManager: Minor default config changes 2010-08-23 00:53:22 -05:00
README
slack-desc

NetworkManager attempts to keep an active network connection available at all
times.  The point of NetworkManager is to make networking configuration and
setup as painless and automatic as possible.  NetworkManager is intended to
replace default route, replace other routes, set IP addresses, and in general
configure networking as NM sees fit (with the possibility of manual override as
necessary).  In effect, the goal of NetworkManager is to make networking Just
Work with a minimum of user hassle, but still allow customization and a high
level of manual network control.

You will probably want to install network-manager-applet (for a configuration
UI) for sure, along with ModemManager (if you want support for configuring
broadband modem connections) perhaps one or more of the VPN-related addons.